next up previous contents index
Next: Write a SNAP Input Up: SNAPIN--Preparing the Input to Previous: Getting a Z-Effective Profile

Enter Comments

Once you have validated all the major submenus by visiting them, you should enter your comments for this shot-try. You will be shown the current comments and you can keep some of these and add new ones. The commands for doing this are always shown.

This section uses a special line-at-a-time input mode--each line is a single command or comment line. This special mode allows you to enter comments without requiring double quotes around them. (Normally a space indicates the end of a response unless it is within double quotes.) Do not put multiple responses on a line.

CURRENT COMMENTS:
 1) repeat of try 1 but use VB for Zeff.  Earlier cases bombed
 2) using VB because the density normalization was off by 10^4.
 3) But try 58505/01 indicated that the zeff from vb would be 3.88.
 4) This case may bomb due to negative thermal ion density

ENTER COMMENTS:  , keeps old comment    * uses old comments from that one on
                 - removes old comment  + to append to current comments
                 ; to end comment list

Do NOT type ahead.  Lines are read one at a time.

<1;>  1? < >:
Repeat of try 1 but use VB for Zeff.
<1;>  2? < >:
-
<1;>  3? < >:
,
<1;>  4? < >:
RETURN

 1) repeat of try 1 but use VB for Zeff.
 3) But try 58505/01 indicated that the zeff from vb would be 3.88.
 4) This case may bomb due to negative thermal ion density

<1;>  4? < >:
Testing SNAPIN and SNAP.
<1;>  5? < >:
;



Marilee Thompson
Fri Jul 11 15:18:44 EDT 1997